Reddy Heater IWH26NLTB Przewodnik Instalacji Pobierz pdf (Strona 12)

www.sureheat.com

200216-01A12

INSTALLATION

Installing Bottom Mounting Bracket

1. Install bottom bracket to heater bottom

with two screws. It may be more conve-

nient to remove heater from wall bracket

to attach.

2. Place heater on wall mounting bracket.

3. Mark screw locations on wall.

4. Remove heater from mounting bracket.

5. If installing bottom mounting screws into hol-

low or solid wall, install wall anchors. Follow

steps 1 through 4 under Attaching To Wall

Anchor Method, page 11. If installing bottom

mounting screw into wall stud, drill holes at

marked locations using 9/64" drill bit.

6. Replace heater onto mounting bracket.

7. Place spacers between bottom mounting

holes and wall anchor or drilled hole.

8. Hold spacer in place with one hand. With

other hand, insert mounting screw though

bottom mounting hole and spacer. Place

tip of screw in opening of wall anchor or

drilled hole.

9. Tighten both screws until heater is rmly

secured to wall. Do not over tighten.

Note: Do not replace front panel at this time.

Replace front panel after making gas connec-

tions and checking for leaks.

Figure 11 - Installing Bottom Mounting

Screws

Wall

Spacer

Heater

Side View

Front View

10,000 Btu

Front View

20,000 Btu or 30,000 Btu

Side View

Front View

10,000 Btu

Front View

20,000 Btu or 30,000 Btu

Figure 12 - Installing Base Feet

INSTALLATION OF BASE STAND

(If Equipped)

Base Feet

Sheet Metal Screws

Before installing heater to base, please make

sure you have a hardware packet that con-

tains the following items:

2 - Base Feet

4 - Sheet Metal Screws

1. Carefully lay heater on its back on a table

with the bottom of the heater extending

outside the table edge.

2. Attach base feet to heater using sheet

metal screws.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag